With increasing cases of COVID-19 (corona-virus), it is advised to follow WHO precautionary measures to be safe and protect others.
Recent
Categories
Tags
Users
View Replies (2)

Resolved Running example simulation and checking output

  1. Soham M
    Soham M
  2. UVM
  3. Saturday, 14 September 2019
How to run the "virtual sequences" / "virtual sequencer" example given in chipverify code examples in codehub. I am trying to run it in Edaplayground, but irun.f file is not working it is not showing any print messages or the topology.Please help.
References
  1. https://www.chipverify.com/verification/codehub
Responses (2)
Soham M
Soham M
Accepted Answer Pending Moderation
In that example of virtual sequences/virtual sequencer of chipverify codehub can we make a run.do file for cadence incisive tool in EDA playground.If so,how to make it.
  1. more than a month ago
  2. UVM
  3. # 1
Admin
Admin
Accepted Answer Pending Moderation
Examples with an irun.f can be used with cadence tool as follows:
$> irun -f irun.f

If you are using it on edaplayground, I would suggest you to look at the links attached below and mimic the settings used in there. You may keep separate files as in the example or club them together into a single file keeping a valid compilation order.
References
  1. https://www.edaplayground.com/x/3YYD
  2. https://www.edaplayground.com/x/3BVb
  1. more than a month ago
  2. UVM
  3. # 2
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.

You consent to our cookies if you continue to use our website. To know more about cookies, see our privacy policy. I accept cookies from this site.

Agree